How to connect grip strut plank in different place?

Let me introduce the way to connect grip strut plank in three different place.First how to connect grip strut plank to I-beam.Second how to connect two grip strut plank in length.Third how to connect two grip strut plank in width.Let me show you one by one

First Grip Strut Plank install to I-beam

Type one:Grip Strut Plank- Fastening anchor Accessories

1.Drilling a pilot hole on I-beam.

2.Using diamond washer,carriage bolt,flat washer,hex nut.

3.Tighten the washer and nut until secure.

The specification of grip strut plank installation fastening anchor Accessories

5/16鈥欌€?18 carriage bolt

5/16鈥欌€ flat washer

5/16鈥欌€?18 hex nut

Second The installation between two Grip Strut Plank in width

Type two:Grip Strut Grating- Fastening anchor Accessories

1. Align two Grip Strut planks side-by-side on I-beam or other anchoring cross-member.

2. Place J-bolts in Grip Strut openings opposite each other. Make sure you choose the openings nearest to the inner edge of the plank .

3. Slide ACA anchor plate up J-bolts until snug. Make sure the inside edge of the ACA anchor plate is as close as possible to the center of the cross member.

4. Tighten nuts until planks are secured.

The specification of grip strut plank installation fastening anchor Accessories

ACA15 1 1/2鈥 Anchor plate

3/8鈥?16 J-Bolts

3/8鈥 Flat Washer

3/8鈥?16 Hex Nut

Second The installation between two Grip Strut Plank in length

Third Grip Strut Plank install to I-beam

Type three:Grip Strut Plank- Fastening anchor Accessories

1.Drilling a pilot hole on splice plates

2.Using Hex bolts,Hex nuts,washers fixed splice plated and grip strut plank

3.Tighten the washer and nut until secure.

The specification of grip strut plank installation fastening anchor Accessories

SP-10DU-30 Splice Plates

1 /2鈥?13 x 11 /4鈥滺ex Bolts

1 /2鈥?13 Hex Nuts

1 /2鈥 Washers